ok ive read the posts about afr, lambda, etc but are there pics of the wideband tuner installed?

also is there a pic of the pressure regular line BACK to the tank installed?

Pulling ski out of water Oct 2nd for winterization. I will have the dealer do all the inspections etc and do a compression check. By then Ill have my ocms fluid analysis back and maybe get 09 pistons out o it at least.

So 2010: 09 pistons
lx cams
hd fuel pump
fpr
1:1 rogue pulley and idler pulley (all this about 1.05 on pump gas and cracked heads bothers me)

goal is 73+mph

We all get dethroned one day. Enjoy it while you can

i took my ultra out at 7 am.

Demographic data: temp - 63 deg, DA - 2602, based on weather - 94.9% avail HP, 5 mph S wind (my cove run E-W), almost smooth water, 3/4 tank 93 octane, storage bucket removed.

1st run - 70.0@7965
2nd run - 70.2@7980
3rd run - 70.3@7995
4th run - 70.2@7980

So there I now have a GPS consistent 70ish u250x in my weather conditions. The increase air flow and sealing the rrp and intake holes helped.

Later in the day a 09 FZR from across the lake wanted to play..by then we had about moderate lake traffic 10 mph wind and some nice chop we both took off..appeared he had me out of the hole but then i pulled even and then went 2-3 boat lengths ahead, hit some rough stuff and stayed ahead....turned around to look, he had already stopped and turned around...still had 3/4 tank and my storage bin in.... so im still the king of speed at my end of loto.....someday i shall be dethroned.....but until then

while i had my jetdock moved today....i drilled out 4 x 1.5 in holes in the ecu cover (2 in the back of the storage bin-when i ride with that in), did the ram air mod, filled all the intake grate and ride plate holes......checked the plugs looked fine to me however, it only took a finger to unloosen them.....apparently not torqued to specs bt my dealer and now waiting for my epoxy stuff to dry,,will take out first thing 2 morrow am ,,,,,,,,,